Logo

P3789 Engine Code Repair

Meaning of P3789 engine trouble code is a kind of powertrain trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

P3789 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for P3789 code is occuring now you should check P3789 repair processes.
Now don't ask yourself; What should you do with P3789 code ?
The solution is here :

P3789 Possible Solution:

P3789 Engine

Power Steering Pressure (PSP) Switch Signal Malfunction The PCM counts the number of times vehicle speed transitions from 0 to a calibratable speed. After a calibratable number of speed transitions the PCM expects that the PSP input should have changed. This DTC is set if the transition is not detected. Vehicle towed with engine running Power steering hydraulic concern was repaired but DTC was not erased PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged Check, if possible, if vehicle was towed or power steering service was performed. Observe PSP V PID while checking wires for intermittents.

P3789 Code Meaning :

P
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine

3
Ignition System Or Misfire

7
Fuel Temperature Sensor B Circuit Range/Performance

8
Cylinder 10 Contribution/balance Fault

9
Clutch Position Sensor Circuit Malfunction

Regarding the P3789 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

P3789 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P3789 engine trouble code is about Clutch Position Sensor Circuit Malfunction.

Main reason For P3789 Code

The reason of P3789 OBD-II Engine Trouble Code is Fuel Temperature Sensor B Circuit Range/Performance.

P3789 DTCs may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.